FLTR.EXE filters incoming DX spots on a PacketCluster link. It passes DX spots only from designated nodes and filters out spots from all other nodes. FLTR is a small TSR that works in conjunction with the G8BPQ packet-switch software. To use FLTR load it after BPQCODE and before DEDHOST FLTR reads the callsigns of allowed nodes from the ASCII file FLTR.NOD. Separate callsigns with any combination of spaces, tabs, commas, and new lines. Use upper or lower case Include any SSIDs in the callsigns. The maximum length of FLTR.NOD is 1024 bytes FLTR displays an error message if it can't find FLTR.NOD, if an error occurs while reading the file, or if the file is too large. FLTR aborts installation and sets ERRORLEVEL to 1 whenever an error occurs. You can test ERRORLEVEL in the batch file you use to load the program Because DX/callsign spots attributed to another callsign also use that callsign as the node, FLTR will remove these spots from the link even if they come from a designated node
